BLTV - Support

Programming SRC-300A Remote
(Remote Solutions)

Program Gateway ID

· Make sure TV is set to Stream 1’s signal (ie. ch 3 or ch 6)

· Push the “Menu” button of Gateway front panel

· Scroll to “Remote Control Setup” using up and down arrows on Gateway

· Press the “Select” button on Gateway front panel

· Press the LED button and hold it down until the LED flashes rapidly.

· Press the REC button. The LED stops blinking at this point and stays solid.

· Press and release the B button.

· Press in the code (i.e. 187) (must be between 004 and 999).

Program Stream (using the remote)

· Press the LED button and hold it down until the LED flashes rapidly.

· Press the REC button. The LED stops blinking at this point and stays solid.

· Press and release the A button.

· Press 1 (for stream 1) or 2 (for stream 2).

Change Stream Channels

· Press the LED button and hold it down until the LED flashes rapidly.

· Press the REC button. The LED stops blinking at this point and stays solid.

· Press and release the A button.

· Press 1 (for stream 1) or 2 (for stream 2).

Program a Remote to a TV

· Start with the TV turned on.

· Press the LED button and hold it down until the LED flashes rapidly.

· Press the REC button. The LED stops blinking at this point and stays solid.

· Press and release the POWER button. The remote is now in TV code scan programming mode.

· Press the UP ARROW button to scan through all the TV codes. When you reach the correct TV code, the TV will automatically turn off.

· Press the SELECT button to store the TV code. The LED flashes rapidly then stops, indicating that the TV code has been stored.

· Repeat the procedure for each remote control.

Congratulations, your remote should now be operational!