BLTV - Support

Programming SRC-200 Remote
(Remote Solutions)

Program Gateway ID

· Make sure TV is set to Stream 1’s signal (ie. ch 3 or ch 6)

· Push the Wrench Button on Gateway front panel

· Scroll to “Remote Control Setup” using up & down arrows

· Press the Select Button on Gateway front panel (check inside of a circle on front of Gateway)

· On remote: Push and hold “B” until red LED light flashes

· On remote: Press PPV to identify Gateway ID or skip this step if you want to create a new Gateway ID

· On remote: Push “7 8 9” and then your gateway ID (ie. 174) - (Gateway ID is found on the TV screen at this point) - (if no ID set, then use 1 and last two numbers of phone #)

· Press the Exit Button on Gateway button panel (far right button on front of Gateway)

Program Stream (using the remote)

· Push and hold “A” until red LED light flashes

· Push “7 8 9 0” (for stream 1 IR)

· Push “7 8 9 1” (for stream 1 RF)

· Push “7 8 9 2” (for stream 2 RF)

Change Stream Channels

· Push the Wrench Button on Gateway front panel

· On remote: press the INFO button

· Push “1 2 3 4”

· Use remote arrows to scroll down to “TV Setup”

· On remote: Press “Select”

· Press remote “left” & “right” arrows or “Select” to change TV Channel (Use “up” & “down” arrows to change between “TV 0 Channel” and “TV 1 Channel”

· Use remote: press “Exit” to return to Main Menu

Program a Remote to a TV

· Manually turn on the TV

· Using remote, press “Mute” and hold until red light at the top of the remote key pad flashes

· On the remote, press “Power”

· Slowly press the down arrow on the remote until the TV goes off

· Press “Select” on the remote

Congratulations, your remote should now be operational!